Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #251

    Hi Kriesi, the transition-container is not displaying anything no image or transitions. I installed wordpress on my laptop for development, if that has anything to do with it? Please advise…

    #30522

    Not sur about that, its hard to help if I cant take a look at the actuall installation. Did you setup the slider correctly? Which means: did you add the images to a page of your choice and set this page as the page that feeds the slider? This is done at appearance->cubit options-> Cubit Starting Page Image Slider

    If that doesnt work, I am afraid you will need to upload it to n actual webserer so I can take a look at it ;)

    #30523

    Thanks Kriesi, I have it working not sure how but its functioning. I created an image page for the slider. I assume the images need to be 900×240 to fill the area otherwise they do not display properly. So I tested with four images all 900×240 and the slider works for the transition but as soon as it completes the image drops a 1.4 inch. Same for the 2nd,3rd and 4th transition ech image drops approximately another 1/4 inch below where the last image dropped to. After the last transition completes there are 4 – 1/4 inch strips of each image showing along the top.

    #30524

    Hi!

    Regards,

    James

    #30525

    Hi!

    Please post the site URL.

    Regards,

    James

    #30526

    Hi James, I had one space between the images and that was causing my problem.

    #30527

    Hey!

    That’s all it takes to break a layout sometimes.

    Glad you got it sorted.

    Regards,

    James

Viewing 7 posts - 1 through 7 (of 7 total)

The topic ‘Cubit successfully installed on wp 3.0 but…’ is closed to new replies.